产品中心
新闻动态 当前位置:首页>新闻动态>新闻动态

了解模具的有关资料

网址:www.paishui.au08.cn  2023-08-17  作者:admin    阅读:

了解模具的有关资料
1. Know about the mould
能取得模具的设计图面,详予分析,并约得模具技师参加试模工作。
It's better to get the design drawing of the mold, analyze it in detail, and ask the mold technician to participate in the mold test.
2.先在工作台上检查其机械配合动作:
2. Check the mechanical cooperation action on the workbench first
要注意有否刮伤,缺件及松动等现象,模向滑板动作是否确实,水道及气管接头有无泄漏,模具之开程若有限制的话也应在模上标明。以上动作若能在挂模前做的话,就可避免在挂模时发现问题,再去拆卸模具所发生的工时浪费。
Attention should be paid to whether there are scratches, missing parts and looseness, whether the movement of the die towards the slide plate is accurate, whether the water channel and air pipe joints have leakage, and if the opening distance of the mold is limited, it should also be marked on the mold. If the above actions can be done before hanging the mold, it can avoid the waste of working time in the process of hanging the mold and then dismantling the mold.
3.当确定模具各部动作得宜后,就要选择适合的试模射出机,在选择时应注意(a)射出容量(b)导杆的宽度(c)最大的开程(d)配件是否齐全等。
3. When determining the appropriate action of each part of the mold, it is necessary to select a suitable test injection machine. In the selection, attention should be paid to (a) the injection capacity (b) the width of the guide rod (c) the maximum opening range (d) whether the accessories are complete.
一切都确认没有问题后则下一步骤就型槽模具 一次性止血带 保定水处理设备 一次性止血带 保定空压机 北京真空泵是吊挂模具,吊挂时应注意在锁上所有夹模板及开模之前吊钓不要取下,以免夹模板松动或断裂以致模具掉落。
After everything is confirmed that there is no problem, the next step is to hang the mold. When hanging, pay attention to lock all clamping templates and do not remove the hanging hook before opening the mold, so as to avoid the clamping template loose or broken, resulting in the mold falling.

返回新闻

网站出租电话
13313028229